Zinc Primer

It is a paint of pure Zinc powder, finely ground, which, through the evaporation of solvents, deposits a coating that electrolytically protects ferrous metals. With a single coat of ZINC PRIMER the passivation, priming and finishing of ferrous surfaces is achieved, even those exposed to the elements, since the chemical reaction of Zinc with rain water or humidity, generates an external film of Zinc Hydroxide, of recognised anti-corrosion power.

  • 7kg metallic drum
  • Boxes of 4 x 1,650kg

ZINC PRIMER

It is a paint of pure Zinc powder, finely ground, which, through the evaporation of solvents, deposits a coating that electrolytically protects ferrous metals. With a single coat of ZINC PRIMER the passivation, priming and finishing of ferrous surfaces is achieved, even those exposed to the elements, since the chemical reaction of Zinc with rain water or humidity, generates an external film of Zinc Hydroxide, of recognised anti-corrosion power.

  • Adheres strongly on clean iron for a long time. The dry film contains 90 % of Zinc with a richness of 98 %.
  • It has a great anticorrosive power. Properly applied, it can be used as a finishing paint.
  • It provides an anti-rust primer equivalent to cold galvanizing. Fully opaque in a single coat.
  • Withstands temperatures up to 300 ºC.

Application Areas

Ferrous surfaces requiring long-lasting antioxidant protection: chemical, naval and chemical industry.

Metallic structures, metallic windows, steam boilers, etc. Its use is important where there are aggressive temperatures and environments.

Instructions for use

Remove embedded dirt and rust residues by brushing using steel rakes. Apply one or two coats of ZINC PRIMER. Allow to dry for a minimum of 12 hours at 20 ºC between coats.

Due to the high concentration of Zinc powder, the product must be removed before and during application.

Apply with temperatures above 5 ºC and relative humidity below 80%. The paint and surface temperature must be above this limit.

Keep stored at temperatures between 8 ºC and 35 ºC. The container can be deformed. Caution when opening.

Data sheet

Appearance
Mate
Colour
Gray
Density (at 20 ºC)
Typical 1.74 kg/l
Application
Brush, airless or spray gun
Theoretical yield
20 m2/L
Drying time
3 hours at 20º C
Cleaning utensils
Water
Solids by volume
56 %
Dilution
Solvent SM. Maximum 10 %.
Touch-drying
30 minutes at 20 ºC
Repainting
Minimum 12 hours at 20 ºC

Specific References

Request safety data sheet:

Name

<p>Terms and Conditions: <a href="http://kalonquimica.com/content/3-terminos-y-condiciones-de-uso">Terminos y condiciones:</a></p>